送料無料: 15,687円+ (トランシーバーとケージ)、 95,070円(その他製品もございます)。大量注文や特注価格については、直接お問い合わせください。
お困りですか?
ライブでチャットしましょう
Live Chat
電話したいですか?

+ 86-752-3386717

Japan · 日本語 · JPY
  • 技術ガイド、業界標準、SFP 互換性に関する詳細情報を詳しくご覧ください。

  • 詳細な製品ベンチマークと並べて比較することで、適切なモジュールを選択するのに役立ちます。

  • データ センター、企業、通信ネットワーク向けの実用的な接続ソリューションを探ります。

  • データ レート、伝送距離、コネクタ タイプの選択に関する重要なヒント。

通貨を選択
USD-米ドル
EUR - ユーロ
GBP - イギリスポンド
CAD - カナダドル
AUD - オーストラリアドル
JPY - 日本円
SEK - スウェーデン クローナ
NOK-ノルウェークローネ
IDR - インドネシア ルピア
BRL-ブラジリアンリアル
THB - タイ バーツ
LS-DAC1110-7MN 7m (23ft) 10g sfp+ to sfp+ passive copper twinax cable
クリックして展開ビューを開きます

LINK-PP LS-DAC1110-7MN 7m (23フィート) 10G SFP+ - SFP+ パッシブ銅ツインアックスケーブル

製品概要

製品
LINK-PP LS-DAC1110-7MN 7m (23フィート) 10G SFP+ - SFP+ パッシブ銅ツインアックスケーブル
SKU
228004
P / N
LS-DAC1110-7MN
価格
5,070円
ステージ0
128在庫あり
SOLD
710
単価 5070円
新規ユーザー: 1,585円 初回注文時に使えるクーポン
CPコード linkpp2610
ご注文金額が一定額以上の場合 158,450円 以上 2,377円 オフ
CPコード Linkpp15
ご注文金額が一定額以上の場合 475,350円 以上 7,923円 オフ
CPコード Linkpp50
ご注文金額が一定額以上の場合 792,250円 以上 15,845円 オフ
CPコード Linkpp100
製造: LINK-PPP / N: LS-DAC1110-7MNSKU: 228004

LINK-PP オリジナルデータシートすべてのダウンロード

ボリューム料金設定 オンライン価格プラン · 大量注文またはカスタム価格についてはお問い合わせください
5070円
1~99個
4817円
100~999個
4665円
1,000~2,999個
4513円
3,000~5,999個
4361円
≥6,000個

これらの数量を超えるご注文、または価格交渉をご希望の場合は、ご連絡ください。

在庫:
128在庫あり
運送:
2,862円
〜へ 日本 、 フェデックスIP
推定配達時間 : 3 - 6 日。
5年保証 15日の返品 15日間交換
保証
  • 業界トップクラスの5年間保証を提供します。
  • 表を読んでください details すべての製品の保証について。
返品と交換
  • 返金は、返品された商品を受け取ってから約5営業日後に処理されます。
  • 交換用の在庫品は、1営業日以内に発送可能です。
  • 返品ポリシー全文をお読みください details.
送料無料 15,687円.
または、チェックアウト時にご自身のUPS / FedEx / DHLアカウントを使用して発送してください(0円 配送)。
数量:
合計金額:
5070円

LINK-PP LS-DAC1110-7MN 7m (23フィート) 10G SFP+ ダイレクトアタッチ銅ケーブル (7メートル、パッシブ、SFP+ - SFP+、24AWG)

その LINK-PP LS-DAC1110-7MN 10G SFP+ ダイレクトアタッチケーブルは、SFF-8431、SFF-8432、およびSFF-8472規格に準拠しています。30~24 AWGのさまざまなワイヤゲージと、最大7mのさまざまなケーブル長を選択できます。この10G SFP+銅ケーブルは、データセンター内のラック内または隣接するラック間で、10ギガビットの短距離接続を確立するための費用対効果の高い接続を提供します。

LINK-PP 部品番号 LS-DAC1110-7MN 業者名 LINK-PP
コネクタ タイプ SFP +からSFP + 最大データレート 10.3125Gbps
ケーブル長 7m(23ft) ケーブルタイプ パッシブTwinax
最小曲げ半径
30 mm ワイヤーAWG
24AWG
メディアの方 銅 電源 3.3V
ジャケット素材 PVC(OFNR) 動作温度範囲 0から70°C
プロトコル InfiniBand QDR、DDR、SDR、10ギガビットイーサネット、ファイバーチャネル×1 用途 10Gイーサネット

機種比較表

LINK-PP

マッチング製品

ピクチャー ID番号 詳細説明 価格 ステージ0 商品をカートに追加

ダウンロード

製品図面 LS-DAC1110-xxN.pdf

Q&A

まだ質問はありません

仕様、互換性、納期について、最初に質問してみましょう。

質問する
  • A:
    The usual failure mode is a rising error count on one lane rather than a hard link down, because a partial break in a twinax pair degrades the signal instead of killing it. That means you can catch it early by monitoring CRC and FEC corrected counters on the port. If a port that has been clean for months starts showing corrected errors that climb steadily, suspect the cable or the connector before the switch. A physical inspection for a kink or a crushed section usually confirms it. by LINK-PP テクニカルサポート
  • A:
    The difference between 1m and 7m of copper is roughly 30 nanoseconds of propagation delay. For storage replication, even synchronous replication, that is negligible compared with the processing and protocol overhead at each end. Where length does matter is in extremely latency sensitive trading or instrumentation systems, and those would not be using 7m passive copper in the first place. For normal enterprise storage traffic, the length difference is not measurable in application terms. by LINK-PP テクニカルサポート
  • A:
    A single 90 degree corner is fine as long as the bend radius stays above the 30mm minimum, which usually means a radius guide or a gentle sweep rather than a sharp corner. What you should avoid is repeated bending at the same point, because the conductor will work harden and the impedance will shift. Install it once, dress it properly, and do not use it as a cable you unplug and re route frequently. If the tray has a genuine sharp corner, add a corner guide. by LINK-PP テクニカルサポート
  • A:
    7m is at the practical limit for passive copper at 10G, which is why this part uses 24AWG and why the assembly is noticeably heavier than the short versions. It works, but the margin is thinner than at 1m, so the quality of the switch cages and the care taken during installation matter more. If your run is genuinely 7m and you cannot shorten it, copper is still viable and cheaper than optics. If the run is longer, or if the path is difficult, fibre is the better answer. by LINK-PP テクニカルサポート

ユーザーレビュー

  • 4.9

    レビューなし

  • 5スター
    95%
    4スター
    5%
    3スター
    0%
    2スター
    0%
    1スター
    0%
データなし
R *** n
Germany
確認済みの購入
5.0
2026-09-11
Used between a pair of switches in a lab where the racks are further apart than usual. Has been up for five months with no flaps.
C *** k
Saudi Arabia
確認済みの購入
5.0
2026-08-12
Labels every metre along the jacket, which is useful when you are pulling a bundle and want to know how much is left.
S *** t
Ireland
確認済みの購入
5.0
2026-07-12
Not flexible, so route it before you connect.
E *** k
ベルギー
確認済みの購入
4.0
2026-06-21
Signal is fine but the stiffness is a real constraint. We had to reroute because it would not make the corner into the manager without a hard bend.
A *** n
Thailand
確認済みの購入
5.0
2026-04-13
We had a specific problem: a pair of switches that could not be moved and were just too far apart for the 5m part once the tray was included. Fibre would have meant new optics on both sides and a media converter on one. This cable solved it for a fraction of the cost and has been running without intervention since the spring maintenance window.
確認済みの購入
.0
表示中 コメント

By 

レビューはまだありません

この製品に関するあなたの体験談を、ぜひ最初に共有してください。

レビューを書く
|
SOLD