送料無料: 15,687円+ (トランシーバーとケージ)、 95,070円(その他製品もございます)。大量注文や特注価格については、直接お問い合わせください。
お困りですか?
ライブでチャットしましょう
Live Chat
電話したいですか?

+ 86-752-3386717

Japan · 日本語 · JPY
  • 技術ガイド、業界標準、SFP 互換性に関する詳細情報を詳しくご覧ください。

  • 詳細な製品ベンチマークと並べて比較することで、適切なモジュールを選択するのに役立ちます。

  • データ センター、企業、通信ネットワーク向けの実用的な接続ソリューションを探ります。

  • データ レート、伝送距離、コネクタ タイプの選択に関する重要なヒント。

通貨を選択
USD-米ドル
EUR - ユーロ
GBP - イギリスポンド
CAD - カナダドル
AUD - オーストラリアドル
JPY - 日本円
SEK - スウェーデン クローナ
NOK-ノルウェークローネ
IDR - インドネシア ルピア
BRL-ブラジリアンリアル
THB - タイ バーツ
LS-DAC1110-5MN 5m (16ft) 10g sfp+ to sfp+ passive copper twinax cable
クリックして展開ビューを開きます

LINK-PP LS-DAC1110-5MN 5m (16フィート) 10G SFP+ - SFP+ パッシブ銅ツインアックスケーブル

製品概要

製品
LINK-PP LS-DAC1110-5MN 5m (16フィート) 10G SFP+ - SFP+ パッシブ銅ツインアックスケーブル
SKU
227955
P / N
LS-DAC1110-5MN
価格
3,169円
ステージ0
290在庫あり
SOLD
710
単価 3169円
新規ユーザー: 1,585円 初回注文時に使えるクーポン
CPコード linkpp2610
ご注文金額が一定額以上の場合 158,450円 以上 2,377円 オフ
CPコード Linkpp15
ご注文金額が一定額以上の場合 475,350円 以上 7,923円 オフ
CPコード Linkpp50
ご注文金額が一定額以上の場合 792,250円 以上 15,845円 オフ
CPコード Linkpp100
製造: LINK-PPP / N: LS-DAC1110-5MNSKU: 227955

LINK-PP オリジナルデータシートすべてのダウンロード

ボリューム料金設定 オンライン価格プラン · 大量注文またはカスタム価格についてはお問い合わせください
3169円
1~99個
3011円
100~999個
2915円
1,000~2,999個
2820円
3,000~5,999個
2725円
≥6,000個

これらの数量を超えるご注文、または価格交渉をご希望の場合は、ご連絡ください。

在庫:
290在庫あり
運送:
2,862円
〜へ 日本 、 フェデックスIP
推定配達時間 : 3 - 6 日。
5年保証 15日の返品 15日間交換
保証
  • 業界トップクラスの5年間保証を提供します。
  • 表を読んでください details すべての製品の保証について。
返品と交換
  • 返金は、返品された商品を受け取ってから約5営業日後に処理されます。
  • 交換用の在庫品は、1営業日以内に発送可能です。
  • 返品ポリシー全文をお読みください details.
送料無料 15,687円.
または、チェックアウト時にご自身のUPS / FedEx / DHLアカウントを使用して発送してください(0円 配送)。
数量:
合計金額:
3169円

LINK-PP LS-DAC1110-5MN 5m (16フィート) 10G SFP+ ダイレクトアタッチ銅ケーブル (5メートル、パッシブ、SFP+ - SFP+、24AWG)

その LINK-PP LS-DAC1110-5MN 10G SFP+ ダイレクトアタッチケーブルは、SFF-8431、SFF-8432、およびSFF-8472規格に準拠しています。30~24 AWGのさまざまなワイヤゲージと、最大7mのさまざまなケーブル長を選択できます。この10G SFP+銅ケーブルは、データセンター内のラック内または隣接するラック間で、10ギガビットの短距離接続を確立するための費用対効果の高い接続を提供します。

LINK-PP 部品番号 LS-DAC1110-5MN 業者名 LINK-PP
コネクタ タイプ SFP +からSFP + 最大データレート 10.3125Gbps
ケーブル長 5m(16ft) ケーブルタイプ パッシブTwinax
最小曲げ半径
30 mm ワイヤーAWG
24AWG
メディアの方 銅 電源 3.3V
ジャケット素材 PVC(OFNR) 動作温度範囲 0から70°C
プロトコル InfiniBand QDR、DDR、SDR、10ギガビットイーサネット、ファイバーチャネル×1 用途 10Gイーサネット

機種比較表

LINK-PP

マッチング製品

ピクチャー ID番号 詳細説明 価格 ステージ0 商品をカートに追加

ダウンロード

製品図面 LS-DAC1110-xxN.pdf

Q&A

まだ質問はありません

仕様、互換性、納期について、最初に質問してみましょう。

質問する
  • A:
    You lose the electrical isolation that fibre provides, which matters if the two ends are on different power systems or different ground potentials. You also lose the ability to test the link with an optical power meter, so fault finding becomes a swap and check process. On the positive side you remove two transceivers, their heat and their firmware, and you gain a link that a junior engineer can replace without any configuration knowledge. For links inside the same row, that trade is usually worth it. by LINK-PP テクニカルサポート
  • A:
    Keep it separated. Passive copper carrying high speed data is susceptible to noise coupling from mains cables, and while the differential signalling is reasonably robust, a long parallel run next to power is asking for trouble. Most standards require a minimum separation, often 50mm or more depending on the voltage and the tray construction. Cross mains cables at right angles if you must cross, and never run them in the same bundle for any distance. by LINK-PP テクニカルサポート
  • A:
    5m gives you about 50cm of margin, which is workable but tight once you allow for a service loop at each end. If your measurement of 4.5m is approximate, the 7m is the safer choice because the extra length can be dressed in a gentle curve without a coil. The penalty for going longer is a slightly heavier cable and marginally more loss, both of which are acceptable. The penalty for going too short is a connector under tension, which is much worse. by LINK-PP テクニカルサポート
  • A:
    Because loss per metre increases as the conductor gets thinner, and at 5m a 30AWG assembly would attenuate the 10G signal beyond what the receiver can recover reliably. 24AWG has a larger cross section and lower resistance, which keeps the insertion loss inside the 10GBASE-CU budget at that length. The trade off is mechanical: the cable is thicker and much stiffer, so it needs a different approach to routing than the short assemblies. by LINK-PP テクニカルサポート

ユーザーレビュー

  • 4.9

    レビューなし

  • 5スター
    95%
    4スター
    5%
    3スター
    0%
    2スター
    0%
    1スター
    0%
データなし
T *** n
Republic of Korea
確認済みの購入
5.0
2026-10-24
We needed 10G between cabinets in the same row and did not want another pair of optics, so we tried the 5m version. It has been stable for four months.
私***K
ウクライナ
確認済みの購入
5.0
2026-09-02
The jacket is marked with the length every metre, which is handy when you are pulling several of them at once.
C *** t
ギリシャ
確認済みの購入
5.0
2026-08-01
Six months, twenty four links, zero replacements. I have nothing interesting to report and that is a good thing.
R *** u
Argentina
確認済みの購入
5.0
2026-07-25
Cost comparison was straightforward. Two SFP+ optics plus a 5m fibre patch was around four times the price of one of these, and we had a spare optics budget line we could redirect. The links have been up since spring with no intervention, and the switch logs show no CRC errors on any of the twelve.
E *** m
Italy
確認済みの購入
5.0
2026-06-15
Twelve of these across two rows, no errors. :)
確認済みの購入
.0
表示中 コメント

By 

レビューはまだありません

この製品に関するあなたの体験談を、ぜひ最初に共有してください。

レビューを書く
|
SOLD