A:
The module draws standard low-voltage power directly from the SFP+ port on a single +3.3V rail. No extra power supplies or external wiring are needed. โดยผู้ดูแลระบบ
A:
It must connect to the dedicated Channel 35 (C35) port on your DWDM multiplexer. The internal laser is fixed precisely to 1549.32nm, so other channel ports will block the optical signal. โดยผู้ดูแลระบบ
A:
No, this DWDM module requires single-mode fiber. Multimode fiber causes extreme modal dispersion with this laser type, which will prevent the link from coming up cleanly. โดยผู้ดูแลระบบ
Running this transceiver across a 28km metropolitan dark fiber leg. Low optical insertion loss and the 10Gbps capability gives us room for future traffic growth =D
Needed an extra C35 DWDM SFP+ transceiver for an indoor lab simulation rack. Optical attenuation levels are well within spec and it operates quietly with minimal heat :-).
Swapped out an older optic for this 10G SFP+ DWDM 1549.32nm transceiver on our secondary edge switch. The 100GHz grid spacing aligned cleanly with our filter unit.
Shipping took an extra day due to local courier backlog. The C35 1549.32nm DWDM SFP+ optic performed without a single glitch during our link commissioning.
Upgraded an ISP aggregation trunk with this C35 40km SMF transceiver module. TX power stays around +0.2dBm and the fiber connection has been dead stable ;)
Great option for cellular tower backhaul deployment where dark fiber is leased. The DOM telemetry reports accurate live RX levels and bias current, matching our calibrated optical tester. We saw zero frame loss or CRC errors across a 48-hour continuous traffic run.
Installed these LS-DW3510-40C DWDM transceivers for a municipal fiber ring connecting several remote office nodes. The EML transmitter provides consistent output power into our mux, and the PIN photodiode receiver handles our 26km span cleanly with plenty of margin above -15.5dBm sensitivity. Highly reliable choice for mid-range metro builds.
We ordered these for an indoor aggregation network serving several warehouse buildings. The LS-DW3510-40C DWDM modules fit our C35 channel plan and worked well with our existing LC fiber panels.
Ordered a batch for high-density DWDM cross-connects in our core telecom room. Even under continuous 10G stress testing, case temperatures hovered around 41°C, safely inside the 0 to 70°C rating. SFP+ MSA compliance made plug-and-play installation completely painless across our multi-vendor hardware.
This 1549.32nm SFP+ module helped us activate an unused 100GHz DWDM channel between two office sites. The 10G link has been steady for daily application traffic. =D
Perfect fit for adding another 10G channel into our existing 100GHz DWDM chassis without replacing fiber lines. The 1549.32nm wavelength stayed completely locked on frequency during rack power-cycle tests. Duplex LC patch leads seat securely with no play.
Good value for a small data room expansion. We checked Tx and Rx values through DOM after installation, and the numbers stayed stable during our test. ;-)
Thailand · English · THB
